Top 5 Metal Roofing Installation Mistakes to Avoid
A roof is the ultimate protection and the crown of a structure that sits elegantly and protects it from several extreme conditions. Therefore, the best of the materials should be opted for roofs that not just provide protection but elegance too. Ticking all the boxes of requirement, the one material that surpasses the others is Metal.
Metal roofing sheets have over the years gained immense popularity considering the versatility and innumerable benefits they offer. However, the installation of Metal Roofing is a crucial aspect. If it is not installed in the most appropriate way, it can cause several concerns like leakages that would outshine the benefit it provides.
Here are a few frequent mistakes to avoid while installing the metal roof:
1. Use of Incorrect Screw Fasteners
Making use of non-standard screws for the installation of metal roofs can result in water leakage. This can eventually cause the roof to become weak. It’s important to use the correct fasteners that are specially designed for metal roof panels. Such fasteners usually seal the opening through a washer, keeping the water at bay. The quality is another factor that we must consider because compromising on the quality will have its own consequences in the long run.
2. Overlapping the Panel in the wrong way
Overlapping the metal roof panels adequately is essential as it doesn’t allow the water to leak from the areas where the panels meet. The required overlapping depends upon the roof slope. It is imperative to determine the pitch of a roof. There are certain recommendations like the amount of overlap required, offered by roofing manufacturers that should be considered too.
3. Extending the roof panels Appropriately over the edge
It is imperative to be precise and leave just the right amount of overhang. If it is altered too short, the water will eventually leak down the sides and gutters. On the other hand, if it is extended too long then the water will not enter the gutters and eventually fall directly on the ground.
It is usually suggested by experts to keep the measurements of the overhang around an inch and a half and two inches. This should be rectified with the instructions provided by the manufacturer.
4. Using very few screws for Pipe Flashing
Penetrations such as PVC pipes are more prone to leakage. Such penetrations should be flashed with the utmost care. It is important to make use of the right number of screws to avoid the use of caulk as an alternative.
5. Relying too much on Sealant
Sealants and caulks are not the primary options for waterproofing. It should be ensured that the application of caulk should be kept away from sunlight and weather. The best and common position for its application is underneath a panel or trim.
Used for several purposes like roof decking, cladding and more, Metal is an impeccable material that is preferred by many. Metal Roof is one of the finest options to avail for the crowning glory of your structure. With Maxroof, avoid the above-given mistakes and install a metal roof in an appropriate manner to reap its benefits to the fullest.
